Tweco Fabricator 141i Operating Manual Uživatelský manuál Strana 47

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 104
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 46
Fabricator 141i
Manual 0-51
45
3-17 INSTALLATION, OPERATION AND SETUP
3.14 Installing 8" (200mm) Diameter Spool
As delivered from the factory, the Power Source is set for a 8" (200mm) diameter spool.
In order to re-fit a 8" (200mm) spool assemble parts in the sequence shown below in Figure 3-12.
Adjustment of the nut with nylon insert will control the MIG Wire Spool Brake. Clockwise rotation of this nut with
nylon insert tightens the brake. The Brake is correctly adjusted when the spool stops within 3/8" (10mm) to 3/4"
(20mm) (measured at the outer edge of the spool) after MIG Gun trigger is released. Wire should be slack without
becoming dislodged from the spool.
CAUTION
Overtension of brake will cause rapid wear of mechanical WIREFEED parts, overheating of electrical
components and possibly an increased incidence of electrode wire Burnback into contact tip.
Ensure that the alignment pin on the wire spool hub aligns with the hole allocated in 8" (200mm)
diameter spool.
NOTE
This alignment pin can be removed by unscrewing in an counterclockwise direction and locating in the
appropriate position.
Art #
A-10358
Spring
Nut with
Nylon Insert
8” (200mm)
diameter spool
Spool Hub Nut
Alignment pin
Brass Flat
Washer
Wire Spool Hub
Friction
Washer
Plastic Spacer
Flat Washer
Alternate
Alignment Pin
Position
Figure 3-12: 8" (200mm) Diameter Spool Installation
Zobrazit stránku 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Yamaha Speaker sets user manuals

Starting on D

Click on an alphabet below to scroll to the full list of models starting with that letter

Models Document Type
DVX-S100
User Manual   DVX-S100 - One Call, 5 pages